RIP (Routing Information Protocol)
Rip is a dynamic routing protocol used in local and wide area networks. It uses the distance-vector routing algorithm I mean,it uses a single routing metric (hop count) to measure the distance between the source and a destination network.Each hop in a path from source to destination is assigned a hop count value, which is typically 1. When a router receives a routing update that contains a new or changed destination network entry, the router adds 1 to the metric value indicated in the update and enters the network in the routing table. The IP address of the sender is used as the next hop.
RIP sends routing-update messages at regular intervals and when the network topology changes. When a router receives a routing update that includes changes to an entry, it updates its routing table to reflect the new route. The metric value for the path is increased by 1, and the sender is indicated as the next hop. RIP routers maintain only the best route (the route with the lowest metric value) to a destination. After updating its routing table, the router immediately begins transmitting routing updates to inform other network routers of the change. These updates are sent independently of the regularly scheduled updates that RIP routers send.
RIP prevents routing loops from continuing indefinitely by implementing a limit on the number of hops allowed in a path from the source to a destination. The maximum number of hops in a path is 15. If a router receives a routing update that contains a new or changed entry, and if increasing the metric value by 1 causes the metric to be infinity (that is, 16), the network destination is considered unreachable. The downside of this stability feature is that it limits the maximum diameter of a RIP network to less than 16 hops.
RIP includes a number of other stability features that are common to many routing protocols. These features are designed to provide stability despite potentially rapid changes in a network’s topology. For example, RIP implements the split horizon and holddown mechanisms to prevent incorrect routing information from being propagated.
RIP uses numerous timers to regulate its performance. These include a routing-update timer, a route-timeout timer, and a route-flush timer. The routing-update timer clocks the interval between periodic routing updates. Generally, it is set to 30 seconds, with a small random amount of time added whenever the timer is reset. This is done to help prevent congestion, which could result from all routers simultaneously attempting to update their neighbors. Each routing table entry has a route-timeout timer associated with it. When the route-timeout timer expires, the route is marked invalid but is retained in the table until the route-flush timer expires.
It is an Interior Gateway Protocol.
This is a configuration example:
router> enable Password: router# conf t router(config)#interface ethernet 0 router(config-if)# ip address 192.168.2.1 router(config-if)# interface ethernet 1 router(config-if)# ip address 192.168.3.1 router(config-if)# exit router(config)# router rip router(config-router)# network 192.168.2.0 router(config-router)# network 192.168.3.0 router(config-router)# exit router(config-router)# ^z router#